Picture your day starting in a clean, well-equipped shop at 5:00 am.
You review a detailed blueprint, choose your tooling, and set up a manual lathe with the kind of care that only years on the floor can teach.
By mid-morning, you’ve moved to the mill, holding tight tolerances and checking critical dimensions.
After lunch, you partner with Engineering to fine-tune a fixture, then verify every feature against GD&T callouts before handing off a flawless component to Quality.
That’s a typical morning in our Gilbert facility—where your skill is the difference between good and world‑class.
Address: 1433 N.
Tech Blvd, Gilbert, AZ 85233
Schedule: Monday–Friday, 1st Shift (5:00 am – 1:30 pm)
Compensation & Benefits: $25–$35 per hour (DOE) plus PTO, 401(k), and Health, Vision, and Dental coverage
Position Type: Full-Time, Hourly (Non-Exempt)
What you’ll doYour craftsmanship turns raw stock into exacting components that our customers depend on.
You’ll be a go-to partner for Engineering and Quality, driving continuous improvement and elevating the standard of our work.
U.S. Person Requirement Due to U.S. export control compliance requirements, candidates must be U.S. citizens, permanent residents, or have protected status under asylum or refugee status.
Position Type: Full-Time, Hourly (Non-Exempt)
Why you’ll enjoy it hereStable first-shift hours, modern equipment, and a tight-knit team that values mastery and pride in workmanship.
If you’re ready to put your manual machining expertise to work where it truly matters, we’d like to meet you.
Send us your resume and a brief note about a challenging manual machining project you’re proud of.